EMT Practice Test

1. Question Content...

---

Question1: Exhibit

The routers shown in the exhibit ate configured for segment routing.
In this scenario, what is the adjacency SIO that Router B advertises to Router A?

Question2: Which two statements ate correct about the BGP next-hop attribute value? (Choose two.)

Question3: Which two statements are correct about the behavior of IS-IS metrics? (Choose two.)

Question4: Exhibit.

Referring to the exhibit, you have configured an aggregate route that represents the 172.21.0.0/24, 172.21.1.0/24, and 172.21.2.0/24 networks. However, when you view the routing table, your new route hidden.
Which action would you perform to determine the problem?

Question5: When would you use the qualified-next-hop statement with a static route?

Question6: You are adding an IPv6 configuration to an Interface on a Junos device.
In this scenario, which statement is correct?

Question7: Exhibit

The LSP is not establishing correctly.
Referring to the exhibit, what should you do to solve the problem?

Question8: You are deploying link aggregation groups.

Question9: Exhibit

Referring to the exhibit, which two statements are correct? (Choose two.)

Question10: Which LSA type does an OSPF ABR use to advertise external routes generated by an NSSAASBR into the backbone?

Question11: Exhibit

You are asked to assign interface xe-1/0/5 to a virtual switch.
What must be accomplished to complete the configuration?

Question12: Exhibit

Referring to the exhibit, which statement is true about VRRP?

Question13: What are three well-known mandatory BGP attributes? (Choose three.)

Question14: Which two statements are correct about the way that BGP propagates routes by default? (Choose two.)

Question15: The segment touting SRGB start label Is 10,000 and the SRGB index range is 500.
In this scenario, which two statements are correct? (Choose two.)

Question16: Exhibit

Referring to the exhibit, which two statements are correct? (Choose two.)

Question17: Which two statements are correct when using LDP? (Choose two.)

Question18: Which OSPF database packet determines which router is in charge of the database synchronization and the transferring of LSA headers between the two systems?

Question19: What are three types of MPLS routers? (Choose three.)

Question20: Exhibit

Which two statements ate correct about the actions taken as the packet traverses the service provider MPLS network from Site 1 to Site 2 as shown in the exhibit? (Choose two.)

Question21: Which new field is added to an IPv6 header as compared to IPv4?

Question22: Exhibit

You are asked to configure the OSPF environment to prevent the DRother routers from participating in DR/BDR election.
Referring to the exhibit, which command will accomplish this task?

Question23: You want to share routes between two routing instances that you have configured?
What are two ways to accomplish this task? (Choose two.)

Question24: Exhibit
S Exhibit
LSI1 A AS 65501
ISPB AS 65502
Advertised Prefixes: 172.20.0.0/24 172.20.20.0/24 172.20.21.0/24
\ N
Advertised Prefixes: 172.20.0.0/24
172.20.1.0/24

Referring to the exhibit, which two statements are correct? (Choose two.)

Question25: You want to enable a routing platform with redundant REs to switch from a primary RE to a backup RE without alerting peer nodes. Which two technologies would you use to satisfy this requirement? (Choose two.)

Question26: You are bringing a new network online with three MX Series devices enabled for STP. No root bridge priority has been configured. Which statement is true in this scenario?

Question27: Exhibit

Which type of load balancing is shown in the exhibit?

Question28: What is the correct order of BGP attributes for active route selection?

Question29: Which two statements ate correct about the community BGP attribute on a Junos device? (Choose two.)

Question30: Which two steps are required to enable MPLS on a physical interface in Junos? (Choose two.)

Question31: You are bringing a new network online with three IS-IS routers using default Junos election priorities. The routers are configured as Level 2 only IS-IS routers. Which statement is true about the DIS election in this scenario?

Question32: Exhibit

Which two statements are correct about the service provider MPLS network shown in the exhibit? (Choose two.)

Question33: Exhibit

Referring to the exhibit, internal BGP between R1 and R2 is not establishing.
What is the problem In this scenario?

Question34: Exhibit

You are advertising a summary route that represents your local network (172.20.0.0716) to both ISP A and ISPB. You want to influence all traffic sent to you from ISP C to go through R2.
How would you accomplish this task?

Question35: Click the Exhibit button.

The routers shown in the exhibit are configured for segment routing.
In this scenario, what is the adjacency SID that Router B advertises to Router A?

Question36: An OSPF router does not have a router ID configured.
In this scenario, which statement is correct about the router ID?

Question37: Exhibit

Which two statements are correct about the information shown in the exhibit? (Choose two.)